That left how to spot weld. There are many YouTube videos showing how to do it with a commercial tool, but one vid showed a homemade welder that was little more than a motorcycle battery, push button, horn relay and some leads. I could do that.
In late 2020, I bought a Ten Tec Omn VI+ transceiver (model 564). It was a big step for me since most Ten Tec equipment I had purchased before was older and pretty inexpensive. The Omni VI+ represented a step up both in performance and cost. Released in 1997 with an MRSP of $2850, It was Ten Tec’s flagship at the time.
In part one of this restoration, we tackled the Ten Tec Omni C’s two most glaring problems: garbled signals on receive and blowing fuses when the radio was switched to the 30-Meter band. I could now receive and transmit signals in almost all the band switch positions, albeit with varying sensitivity and power output. It had been quite a chase so far, and the remaining repairs would prove equally challenging.
I purchased a Ten Tec Omni Series C transceiver about a year ago for my collection. At the time, I was in the middle of several other projects, and didn’t get to it until just recently. I had been using an Omni D, but it still needs work and I thought the “C” would be a nice upgrade.
I finished circuit repairs on a Ten Tec Triton IV transceiver and now it was time to address the grubby cosmetics of the radio. The radio had obviously been used as a mobile. Markings had been added to the front panel in Sharpie, and there was a yellowish film on the panel.
In the last post, I described a used Ten Tec Triton IV and addressed the most immediate issues. I also mentioned making a cosmetic restoration, but after using it in the shack for an evening, it was apparent there were other problems. The “Offset Tuning” (OT) LED didn’t work, and more seriously, the transceiver didn’t always mute in transmit. Strange sounds issued from the speaker at times.
eBay has provided a lot of entertainment (and used equipment!) over the last few months, and after the purchase and restoration of a Ten Tec Century 21, I started looking for a Triton IV. This was the first radio I purchased new in 1978. I really enjoyed it and wanted to own one again. It didn’t take long. I ended up having two in the shop at almost the same time — one for my shack, and one for a fellow ham.
The Ten Tec Triton I/II transceivers were released in the mid-1970’s and marked a milestone in High Frequency (HF) radios. With coverage for the 80, 40, 20, 15 and 10-meter amateur radio bands, 50 to 100 watt output on SSB and CW, they may have been the first affordable, fully solid-state models.
I look at Ebay from time-to-time, and lately I’ve been having a little too much fun. A Ten Tec Century 21 CW Transceiver (model 570) attracted my attention recently. The “570” was a solid-state radio intended for Novice hams and covered five bands: 80, 40, 20 (and with accessory crystals) 15 and 10 meters.
I mentioned finding two old 20’s-era broadcast receivers in an earlier post. Some months had passed, and restoring the Freshman Masterpiece “5F5” seemed like a fun project and a quick win. The radio was designed to run on two batteries: an “A” or 6-volt battery for the tube filaments and a “B” or 90-volt battery for the plate voltage.